ELTEX NTU-RG-1402G-W - Route Submenu: Routing Table

____________________________________________________________________________________
____________________________________________________________________________________
NTU-2V, NTU-RG Optical Network Terminals 37
The use of UPnP requires NAT setup on an active WAN interface.
Set the Enable UPnP flag to enable the function.
Click the Apply/Save button to accept and save the settings.
4.4 The Voice Menu. SIP Telephony Settings
1
4.4.1 The SIP Basic Setting Submenu. SIP General Settings
— SIP proxy – address of the SIP server which is used for users registration;
— Use SIP Proxy – when the flag is set, the following SIP Proxy server is used:
— SIP Proxy – SIP Proxy address;
— SIP Proxy port – SIP Proxy port;
— Use SIP Outbound Proxy – when the flag is set, SIP Outbound-proxy is used to send all queries; it is not
used otherwise.
— SIP Outbound Proxy – address of the SIP proxy which will be used to transfer all queries
(this server will be used for routing of SIP Proxy and SIP Registrar queries);
— SIP Outbound Proxy port – port of the SIP proxy which will be used to transfer all queries;
— Use SIP Registrar – when the flag is set, the following SIP registration server is used:
— SIP Registrar – server address;
— SIP Registrar port – server port.
The table shows SIP parameters that are common for both FXS ports.
— SIP Account – SIP account (FXS port number);
— Enable – when the flag is set, the port is enabled;
— Number – phone number;
— Display name – user name displayed;
1
If the menu is not presented in configuration, the parameters have already been configured by you operator.