BA-en-3041-2008_PC 61
4.4.2.5 Parameters
Press the "Parameters" button.
Change the parameter value using either the slide switch or the selection
list, then confirm with OK. If you do not have the required access authori-
zation, you will have to enter a password. Select “Change all” to set all
parameters that can be changed with the current access authorization;
wait for the confirmation.
Note that the parameter list contains only entries that may be read with the
current access authorization. Access authorizations are defined under
"Configuration => Access Management".
Fig. 44:
Overview of
parameters
B00344
To Next Page
Loading...
