EasyManua.ls Logo

ELTEX SBC-1000 - Page 136

ELTEX SBC-1000
211 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
136 SBC session border controllers
QoS_control
Enter the QoS parameter configuration mode
quit
Terminate this CLI session
save mirroring
Save mirroring settings without applying
save vlan
Save VLAN settings without applying
set mirroring
<PORT>
<NAME>
<ACT>
GE_PORT0(0)/
GE_PORT1(1)/
GE_PORT2(2)/
CPU(4)/
SFP0(6)/
SFP1(7)
src_in/
src_out/
dst_in/
dst_out
on/off
Configure port mirroring:
PORT port type;
NAME port designation:
- src_in incoming packet source port copy
frames received from this port (source port);
- src_out outgoing packet source port copy
frames transmitted by this port (source port);
- dst_in incoming packet destination port
receiver port for the copied frames received by the
selected source ports;
- dst_out outgoing packet destination port
receiver port for the copied frames transmitted by
the selected source ports;
set port backup
<ON_OFF>
<B_MASTER>
B_SLAVE
on/off
GE_PORT0/GE_PORT1/
GE_PORT2/SFP0/SFP1
GE_PORT0/GE_PORT1/
GE_PORT2/SFP0/SFP1
Enable Dual Homing redundancy
B_MASTER main port
B_SLAVE redundant port
PREEMPTION enable/disable return to the main
port when it is restored
set port
default vlan id
<PORT>
<VLANID>
GE_PORT0(0)/
GE_PORT1(1)/
GE_PORT2(2)/
CPU(4)/
SFP0(6)/
SFP1(7)
0-4095
Assign VLAN ID to this port.
set port egress
<PORT>
<EGRESS>
GE_PORT0(0)/
GE_PORT1(1)/
GE_PORT2(2)/
CPU(4)/
SFP0(6)/
SFP1(7)
unmodified/
untagged/
tagged/
double-tag
Set the packet transmission mode on this port.
EGRESS packet transmission mode:
unmodified packets are transmitted by this
port unchanged (i.e. in the same form as they
came to the other port of the switch);
untagged packets will always be sent
without VLAN tag by this port;
tagged packets will always be sent with
VLAN tag by this port;
Double tag each packet will be sent with
two VLAN tags if received packet was
tagged and came with one VLAN tag if the
received packet was untagged.
set port ieee
mode
<PORT>
GE_PORT0(0)/
GE_PORT1(1)/
Set the received tagged packet control mode for this
port.

Table of Contents