ELTEX SBC-1000 - Page 137

SBC session border controllers 137
<IEEE>
GE_PORT2(2)/
CPU(4)/
SFP0(6)/
SFP1(7)
fallback/
check/
secure
IEEE — packet control mode:
– Fallback — if a packet with VLAN tag is
received through this port, and there is a
record in a routing table for this packet, then it
falls within a scope of routing rules, specified in
the record of this table; otherwise, routing
rules specified in «egress» and «output» will
be applied to it;
– Check — if a packet with VID is received
through the port, and there is a record in a
«802.1q» routing table for this packet, then it
falls within a scope of routing rules, specified in
the current record of this table, even if this
port does not belong to the group of this VID.
Routing rules specified in «egress» and
«output» will not apply to this port;
– Secure — if a packet with VID is received
through the port, and there is a record in a
«802.1q» routing table for this packet, then it
falls within a scope of routing rules, specified in
the current record of this table; otherwise, it is
rejected. Routing rules specified in «egress»
and «output» will not apply to this port.
set port
LACP_trunk
1
<PORT>
<LACP>
CPU/
GE_PORT0/
GE_PORT1/
GE_PORT2/
SFP0/
SFP1
0-4
Assign LACP trunk for the specified port.
set port MAC
GE_PORT0
<MACADDR>
MAC address in
format of
XX:XX:XX:XX:XX:XX
Specify MAC address for port
set port output
<PORT>
<P_DEST>
<ENABLE>
GE_PORT0/
GE_PORT1/
GE_PORT2/
CPU/
SFP0/
SFP1
GE_PORT0/
GE_PORT1/
GE_PORT2/
CPU/
SFP0/
SFP1
on/off
Setting permissible ports for sending packets
PORT — configurable port
P_DEST — permitted sending port
set port speed
<SPEED>
1000M
100M (full-duplex/
half-duplex)
10M(full-duplex/
half-duplex)
auto
Set port operation mode
1
Not supported in the current firmware version