ELTEX SBC-1000 - Page 138

138 SBC session border controllers
<PORT>
GE_PORT0/GE_PORT1/
GE_PORT2
set port vlan
enabling
<PORT>
<ENABLE>
CPU/
GE_PORT0/
GE_PORT1/
GE_PORT2/
SFP0/
SFP1
on/off
Enable/disable VLAN on this port
set port vlan
override
<PORT>
<OVER>
CPU/
GE_PORT0/
GE_PORT1/
GE_PORT2/
SFP0/
SFP1
on/off
Set the VLAN ID override mode for this port to
standard
show mirror
settings
Show port mirroring parameters
show port
settings
Show port configuration parameters
4.2.7.23.1 802.1q parameter configuration mode
To enter this mode, execute '802.1q' command in the switch configuration mode.
SBC-[CONFIG]-[SWITCH]> 802.1q
Entering 802.1q_control mode.
SBC-[CONFIG]-[SWITCH]-[802.1q]>
Command
Parameter
Value
Action
?
Show the list of available commands.
add VTU element
<VID>
<PRIO>
<OVER>
<GE_PORT0>
<GE_PORT1>
<GE_PORT2>
<CPU>
<SFP0>
<SFP1>
0-4095
0-7
on/off
unmodified/
untagged/
tagged/
not_member
unmodified/
untagged/
tagged/
not_member
unmodified/
untagged/
tagged/
not_member
unmodified/
untagged/
tagged/
not_member
unmodified/
untagged/
tagged/
not_member
unmodified/
untagged/
tagged/
not_member
Add new element to VTU table:
VID — VLAN identifier;
PRIO — 802.1р priority, assigned to packets in the
given VLAN, if the OVER parameter is active (on);
OVER — overwrite 802.1р priority for the given
VLAN (yes/no);
PORT — actions performed by this port when
transmitting a packet with the specified VID:
– Unmodified — packets will be sent by the
port without any changes;
– Untagged — packets will always be sent
without VLAN tag by this port;
– Tagged — packets will always be sent with
VLAN tag by this port;
– Not member — packets with specified VID
will not be sent by this port (i.e. the port is
not the member of VLAN)
apply
<YES_NO>
yes/no
Apply VTU settings