ELTEX SBC-1000 - Page 139

SBC session border controllers 139
confirm
Confirm VTU settings. You have 1 minute to confirm
settings, or the previous values will be restored.
exit
Return from this configuration submenu to the
upper level.
QoS_control
Go to the QoS configuration mode
quit
Terminate this CLI session
remove VTU
element
<NUMBER>
0-4095
Remove the given VTU table element
save
Save VTU settings without applying
set VTU override
<NUMBER>
<OVER>
0-4095
on/off
Overwrite/ not overwrite 802.1р priority for the
given VLAN (yes/no)
set VTU priority
<NUMBER>
<PRIO>
0-4095
0-7
Set the 802.1p priority assigned to packets on this
VLAN if the «set VTU override» parameter is active
set VTU
settings_CPU
<NUMBER>
<CPU>
0-4095
unmodified/
untagged/
tagged/
not_member
Assign actions performed by this port when
transmitting a packet with the specified VID
– Unmodified — packets will be sent by the
port without any changes;
– untagged — packets will always be sent
without VLAN tag by this port;
– tagged — packets will always be sent with
VLAN tag by this port;
– Not member — packets with specified VID
will not be sent by this port (i.e. the port is
not the member of VLAN)
settings_GE_PORT0
<NUMBER>
<CPU>
0-4095
unmodified/
untagged/
tagged/
not_member
Assign actions performed by this port when
transmitting a packet with the specified VID
– Unmodified — packets will be sent by the
port without any changes;
– untagged — packets will always be sent
without VLAN tag by this port;
– tagged — packets will always be sent with
VLAN tag by this port;
– Not member — packets with specified VID
will not be sent by this port (i.e. the port is
not the member of VLAN)
settings_GE_PORT1
<NUMBER>
<CPU>
0-4095
unmodified/
untagged/
tagged/
not_member
Assign actions performed by this port when
transmitting a packet with the specified VID:
– Unmodified — packets will be sent by the
port without any changes;
– untagged — packets will always be sent
without VLAN tag by this port;
– tagged — packets will always be sent with
VLAN tag by this port;
– Not member — packets with specified VID
will not be sent by this port (i.e. the port is
not the member of VLAN)
settings_GE_PORT2
<NUMBER>
<CPU>
0-4095
unmodified/
Assign actions performed by this port when
transmitting a packet with the specified VID: