ELTEX SBC-1000 - Page 140

140 SBC session border controllers
untagged/
tagged/
not_member
– Unmodified — packets will be sent by the
port without any changes;
– untagged — packets will always be sent
without VLAN tag by this port;
– tagged — packets will always be sent with
VLAN tag by this port;
– Not member — packets with specified VID
will not be sent by this port (i.e. the port is
not the member of VLAN)
settings_SFP0
<NUMBER>
<CPU>
0-4095
unmodified/
untagged/
tagged/
not_member
Assign actions performed by this port when
transmitting a packet with the specified VID:
– Unmodified — packets will be sent by the
port without any changes;
– untagged — packets will always be sent
without VLAN tag by this port;
– tagged — packets will always be sent with
VLAN tag by this port;
– Not member — packets with specified VID
will not be sent by this port (i.e. the port is
not the member of VLAN)
settings_SFP1
<NUMBER>
<CPU>
0-4095
unmodified/
untagged/
tagged/
not_member
Assign actions performed by this port when
transmitting a packet with the specified VID:
– Unmodified — packets will be sent by the
port without any changes;
– untagged — packets will always be sent
without VLAN tag by this port;
– tagged — packets will always be sent with
VLAN tag by this port;
– Not member — packets with specified VID
will not be sent by this port (i.e. the port is
not the member of VLAN)
show list
Show list of item in VTU table
show one
<NUMBER>
0-4095
Show information about the given VTU table item
show table
Show VTU table
4.2.7.23.2 QoS parameter configuration mode
To enter this mode, execute 'QoS_control' command in the switch or 802.1q configuration mode.
SBC-[CONFIG]-[SWITCH]> QoS_control
Entering QoS_control mode.
SBC-[CONFIG]-[SWITCH]-[QoS]>
Command
Parameter
Value
Action
?
Show the list of available commands.
802.1q
Return to the 802.1q parameter configuration
mode
apply
<YES_NO>
yes/no
Apply QoS settings