154 SBC session border controllers
lacp port-priority
This command sets the priority for the configurable port. The priority is set in the range [1 .. 65535]. 1 is the highest
priority.
The use of a negative form (no) of the command sets the default priority value.
Syntax
lacp port-priority <priority>
no lacp port-priority
Parameters
<PRIORITY> — the priority for this port is [0 .. 65535].
Default value
all ports are set to priority 32768
Command mode
INTERFACE FRONT-PORT
Example
SBC2000-[CONFIG]-[SWITCH]-[if]> lacp port-priority 256
Port 256 priority is set on the configurable ports.
lacp rate
This command sets the transmission interval of control packets of LACPDU protocol.
The use of the negative form of the command (no) sets the transmission interval of control packets of the LACPDU
protocol by default.
Syntax
lacp rate <rate>
no lacp rate
Parameters
<rate> — transmission interval:
fast — transmission interval is 1 second;
slow — transmission interval is 1 second.
Default value
1 seconds (fast)
Command mode
INTERFACE FRONT-PORT
Example
SBC2000-[CONFIG]-[SWITCH]-[if]> lacp rate slow
LACPDU control packets transmission interval is set to 30 seconds.
To Next Page
Loading...