SBC session border controllers 157
Syntax
[no] spanning-tree admin-edge
Parameters
Command contains no arguments.
Default value
off
Command mode
INTERFACE FRONT-PORT
INTERFACE PORT-CHANNEL
Example
SBC2000-[CONFIG]-[SWITCH]-[if]> spanning-tree admin-edge
For the configured port, the type of edge-link connection is enabled.
spanning-tree admin-p2p
This command defines the type of p2p connection definition.
The use of a negative form (no) of the command sets the default p2p connection definition type.
Syntax
spanning-tree admin-p2p <type>
no spanning-tree admin-p2p
Parameters
<type> — connection definition type:
auto — the definition is based on BPDU;
force-false — forced link as a non p2p;
force-true — forced link as a p2p.
Default value
p2p connection type is determined based on BPDU
Command mode
INTERFACE FRONT-PORT
INTERFACE PORT-CHANNEL
Example
SBC2000-[CONFIG]-[SWITCH]-[if]> spanning-tree admin-p2p auto
For the configured port, the connection type p2p is defined on the basis of BPDU.
spanning-tree auto-edge
This command sets the automatic bridge detection on the configured interface.
The use of a negative form (no) of the disables automatic bridge detection on the configured interface.
The automatic bridge detection feature is enabled by default.
To Next Page
Loading...