ELTEX SBC-1000 - Page 161

SBC session border controllers 161
<port> — sequential number of the port of the front-port group in the format <unit/port>, where:
 for front port: <unit/port>, where:
 unit — module number, may take value [1],
 port — port number, may take values: [0 .. 3];
 for port-channel: [0 .. 4].
Command mode
CONFIG-SWITCH
Example
SBC2000-[CONFIG]-[SWITCH]> mirror rx analyzer front-port 1/2
Data for external analysis will be duplicated to the front-port 1/2 from the port/ports where the option
«mirror incoming traffic» is set.
mirror add-tag
This command adds the 802.1q mark to the traffic being analyzed. Setting the tag value can be done by the
command mirror <rx/tx> added-tag-config.
The use of the negative form of the command (no) removes the tag.
Syntax
[no] mirror add-tag
Parameters
Command contains no arguments.
Command mode
CONFIG-SWITCH
Example
SBC2000-[CONFIG]-[SWITCH]> mirror add-tag
mirror <rx|tx> added-tag-config
This command allows you to set a tag value that can be added to the analyzed incoming/outgoing traffic.
Syntax
mirror <rx|tx> added-tag-config vlan <vid> [user-prio <user-prio>]
Parameters
<vid> — VLAN ID, may take values [1 .. 4094];
<user-prio> — COS priority, takes values from [0 .. 7].
Command mode
CONFIG-SWITCH
Example
SBC2000-[CONFIG]-[SWITCH]> mirror rx added-tag-config vlan 77 user-prio 5