ELTEX SBC-1000 - Page 167

SBC session border controllers 167
Example
SBC2000-[CONFIG]-[SWITCH]> lldp enable
lldp hold-multiplier
This command specifies the amount of time for the receiver to keep LLDP packets before dropping them.
This value will be transmitted to the receiving side in the LLDP update packets; and should be an increment for the
LLDP timer. Thus, the lifetime of LLDP packets is calculated by the formula: TTL = min(65535, LLDP-Timer * LLDP-
HoldMultiplier).
The use of a negative form (no) of the command sets the default value.
Syntax
lldp hold-multiplier <hold>
no lldp hold-multiplier
Parameters
<hold> — time, may take values [2 .. 10] seconds.
Default value
The default value is 4 seconds.
Command mode
CONFIG SWITCH
Example
SBC2000-[CONFIG]-[SWITCH]> lldp hold-multiplier 5
lldp reinit
This command sets ninimum amount of time for the LLDP port to wait before LLDP reinitialization.
The use of a negative form (no) of the command sets the default value.
Syntax
lldp reinit <reinit>
no lldp reinit
Parameters
<reinit> — time, may take values [1 .. 10] seconds.
Default value
The default value is 2 seconds.
Command mode
CONFIG SWITCH
Example
SBC2000-[CONFIG]-[SWITCH]> lldp reinit 3