190 SBC session border controllers
5. Rule set configuration (menu SBC Configuration/Rule set, section 4.1.3.5).
Create two rule sets. In the first «SIP Destination» field, specify the destination that was configured for
Softswitch. In the second, specify the trunk gateway destination.
6. Bind the rule to destinations.
To bind in the destination settings for Softswitch in the «SIP Users» section select a rule set, where in the field
«SIP destination» specified the trunk gateway destination. Accordingly, in the destination settings for the trunk
gateway, select a different set of rules, directing everything to Softswitch.
The SIP destination table will be as follows:
7. To apply the settings, save the configuration to Flash (menu Service/Save configuration to flash, section
4.1.12).
To Next Page
Loading...