SBC session border controllers 73
Network subsystem –> Routing table –> «Add»
To add a new route, set the following parameters:
Enable — when checked, the route is available for use;
Destination — IP network, IP address or default (to set the
«default» gateway);
Mask — specify a network mask for the defined IP network
(use mask 255.255.255.255 for IP address).
Gateway — define IP address of route gateway.
Interface — select the network transmission interface (if not
checked, the most appropriate interface will be selected
based on the gateway address);
VPN route — transmission interface associated with the VPN
client account. The route and address will be automatically
set through the associated network interface when the VPN
client establish the connection;
Metric — route metric.
«Apply» and «Cancel» buttons, are used to save and reset parameters respectively.
4.1.4.2 Network Settings
In this submenu, you may specify the device name, change the network gateway address, DNS server address
and SSH/Telnet access ports.
Network subsystem –> Network settings
– Hostname — network name of the device;
– Use gateway from — select network interface that the
gateway will consider as a primary for the device;
– Primary DNS — primary DNS server;
– Secondary DNS — secondary DNS server;
– Port for SSH — TCP port for the device access via SSH pro-
tocol, default value is 22;
– Port for Telnet — TCP port for the device access via Telnet
protocol, default value is 23.
4.1.4.3 Network interfaces
The device allows you to configure 1 primary network interface eth0 and up to 9 additional interfaces; these
interfaces may include VLAN interfaces as well as Aliases for primary interface eth0 or VLAN interface.
Alias — additional network interface based on the existing primary network interface eth0 or VLAN interface.
Network subsystem –> Network interfaces
To Next Page
Loading...