78 SBC session border controllers
Network services –> SNMP (SNMP traps settings)
– Restart SNMPd — SNMP client restarts when the button is clicked;
Network services –> SNMP (SNMP traps settings)
–> «Add»
Up to 16 traps can be created. To create, edit or remove trap parameters, use
the following buttons:
– "Add";
– «Edit»;
– «Delete».
– Type — SNMP message type (TRAPv1, TRAPv2, INFORM);
– Community — password contained in traps;
– IP-address — trap recipient IP address;
– Port — trap receiver UDP port.
4.1.5.2.4 Retrieving MIB files
In the current firmware version, you can download the current MIB files directly from the device by clicking
the «Download MIB-files» button.
4.1.5.3 VPN/PPTP server
Network services –> VPN/PPTP server
VPN/PPTP server settings
– Enabled — start the service at startup/reboot;
– Server address — IP address that will be reported as
the server address to all connecting PPTP clients;
– First client address, Last client address — range of IP
addresses assigned to PPTP clients;
– Network interface — select the interface to connect
to the VPN/PPTP server;
– DNS server — address of the DNS server, which will
be reported to clients;
– Max clients count — number of simultaneous client
connections;
– Enable encryption — encryption of transmitted data
(must also be enabled on the client);
– Enable Web, Enable Telnet, Enable SSH — when
checked, the corresponding management service is
available at the specified interface address;
– Enable SNMP — enables SNMP utilization through
the interface;
– Enable RADIUS — enables RADIUS protocol
utilization through the interface.
To Next Page
Loading...