SBC session border controllers 85
– Speed limit for ingress queued packets 0 — bandwidth restriction for traffic incoming to a queue 0 port.
Permitted values—from 70 to 250000kbps.
– Speed limit for ingress queued packets 1 — bandwidth restriction for traffic incoming to a queue 1 port. You
can double the bandwidth (prev prio *2) of priority 0, or leave it unchanged (same as prev prio).
– Speed limit for ingress queued packets 2 — bandwidth restriction for traffic incoming to a queue 2 port. You
can double the bandwidth (prev prio *2) of priority 1, or leave it unchanged (same as prev prio).
– Speed limit for ingress queued packets 3 — bandwidth restriction for traffic incoming to a queue 3 port. You
can double the bandwidth (prev prio *2) of priority 2, or leave it unchanged (same as prev prio).
– Egress packets limit mode — when this flag is checked, bandwidth limitation for outgoing traffic from the port
is allowed;
– Speed limit for egress packets — bandwidth limitation for outgoing traffic from the port. Permitted values —
from 70 to 250000kbps.
– Apply — apply defined settings;
– Confirm — confirm modified settings;
Click 'Confirm' button in 1-minute interval to confirm settings, or the previous values will be
restored.
– Default — set default settings;
– Save — save settings into the device flash memory without applying them.
4.1.6.5 Queue priority mapping
In the section "QoS and bandwidth control", Quality of Service (QoS) functions are configured.
Network switch –> Queue priority mapping
To Next Page
Loading...