ELTEX SMG-4 - Page 137

SMG digital gateway 137
<ACTION>
<P_IDX>
timestamp-request
timestamp-reply
address-mask-request
address-mask-reply
accept, drop, reject
1-65535
Action—an action executed by this rule:
ACCEPT—the packets corresponding this
rule will be accepted by the firewall.
DROP—the packets corresponding this
rule will be rejected by the firewall
without informing the party that has sent
them.
REJECT—the packets corresponding this
rule will be rejected by the firewall. The
party that has sent the packet will receive
either a TCP RST packet or "ICMP
destination unreachable".
Firewall profile number
apply
Apply firewall settings
config
Return to the Configuration menu
del profile
<ID>
1-65535
Remove a firewall profile
del rule
<ID>
1-65535
Remove a firewall rule
exit
Return from this configuration submenu
to an upper level
modify profile
<ID>
<NAME>
1-65535
Allowed characters:
letters, numbers, "_";
63 characters max.
Firewall profile index
Enter a new name for the device
modify rule
<Type>
<ID>
<param>
action dport_end
dport_start enable
icmp-type
name
prof_id
proto
r_ip r_mask
s_ip s_mask
sport_end sport_start
traffic-type
1-65535
A new value according
to this parameter type
Modify the specified firewall rule (one of
the parameters)
move down
<ID>
1-65535
Move the rule one position down
move up
<ID>
1-65535
Move the rule one position up
quit
Terminate this CLI session
set eth
<PROFILE ID>
0-65535
Assign a rule to a network interface
PROFILE ID = 0 means that the profile is
not used
set pptp
<PPP_IDX>
0-5
Assign a rule to an interface