ELTEX SMG-4 - Page 148

148 SMG digital gateway
4.3.13.1 NTP Configuration Mode
To enter this mode, execute the ntp command in the network configuration mode.
SMG4-[CONFIG]-NETWORK> ntp
Entering NTP mode.
SMG4-[CONFIG]-[NETWORK]-NTP>
Command
Parameter
Value
Action
?
Show the list of available commands
apply
no/yes
Apply NTP settings
config
Return to the Configuration menu
exit
Return from this configuration
submenu to an upper level
quit
Terminate this CLI session
restart ntp
no/yes
Restart the NTP process
set ntp
dhcp
period
server
usage
off/on
10-1,440
IP address in the
AAA.BBB.CCC.DDD
format
off/on
Obtain NTP settings via DHCP
Set the synchronisation period
Set an NTP server
Enable/disable NTP usage
show config
Show configuration
set timezone
GMT/GMT+1/GMT-
1/GMT+2/GMT-
2/GMT+3/GMT-
3/GMT+4/GMT-
4/GMT+5/GMT-
5/GMT+6/GMT-
6/GMT+7/GMT-
7/GMT+8/GMT-
8/GMT+9/GMT-
9/GMT+10/GMT-
10/GMT+11/GMT-
11/GMT+12
Specify a time zone with respect to
UTC
4.3.13.2 SNMP Configuration Mode
To enter this mode, execute the snmp command in the configuration mode.
SMG4-[CONFIG]-NETWORK> snmp
Entering SNMP mode.
SMG4-[CONFIG]-SNMP>
Command
Parameter
Value
Action
?
Show the list of available commands
add
<TYPE>
trapsink/
trap2sink/
informsink
Add a rule for SNMP trap transmission:
TYPE—SNMP message type;
IP—IP address of the trap recipient;
COMM—the password contained in
traps;
PORT—UDP port of the trap recipient.
<IP>
IP address in the
AAA.BBB.CCC.DDD
format
<COMM>
String, 31 characters
max.