– Dialed digits–digits dialled by the port before modification according to the routing plan;
– Registration state–SIP server registration status:
• off–registration disabled;
• ok–successful registration;
• failed–registration failed.
– Last registration at–last known successful registration on SIP server;
– Next registration after–remaining time for SIP server registration renewal;
– H.323 GK–H.323 gatekeeper registration time;
– Test–testing parameters of a subscriber line corresponding to this port;
– FXS statistic–request statistics of voice traffic transmission for this port.
Information about the blocking
If port was in 'blocked' state, then 'Last block cause' link will be active (reason and time of the last known port
blocking):
– leakage current has exceeded the permissible parameters–leakage
current block;
– temperature current has exceeded the permissible parameters–
temperature block;
– power dissipation has exceeded the permissible parameters–power dissipation block;
– reinitialization by changing the input voltage–port reinitialization due to input voltage fluctuations;
– hardware reset–hardware reset;
– low Vbat level–low input voltage level;
– FXS port out of order–port is out of order/faulty;
– Receiver offhook–offhook block. If the subscriber's phone is offhook, and the 'busy' tone is played, after the
expiry of two-minute interval the 'Receiver offhook' tone will be played to the subscriber's phone, and the
port will switch into the blocked state.
If the port is already in 'blocked' state, and the 'Last block cause' link is inactive, it means that the port was
blocked when the phone is offhook. This blocking will be performed after the 'busy' tone is played to the subscriber's
phone for two minutes. Upon the expiry of this time interval, a loud triple-tone will be played to the subscriber's
phone notifying them that the phone is offhook.
To save the changes you must click the Save button.
When you click on the Hide blocking info button information on blocking will be removed.
When you click the Hide all button the results of tests of all types will be removed.
Port test
To Next Page
Loading...
