page 2 of 9 008TA14 BU-094-A Revision : 7 Page 2 / 9
IMPORTANT SAFETY NOTES!
Please read this manual carefully before using this product. Warranty claims cannot be
considered if damage is caused by failure to comply with these operating instructions!
This documentation was compiled with the utmost care, however, we cannot guarantee for
its correctness in every respect.
Product Description
The eltherm Series EL-TC 14X electronic temperature controllers are designed for monitoring and control of
heating and heat tracing circuits. The temperature controller comes complete with a single circuit 20A
switching output and additional 8A alarm relay. The controller is designed to operate with 3-wire or 2-wire
Pt100 RTD temperature sensors (optionally supplied by eltherm). ELTC-14 series controllers are supplied fully
integrated in weather-proof enclosures, suitable for wall mounting, complete with transparent cover to allow for
viewing and access to the front panel and user interface of the controller.
Controller Operation
Operation of the controller and the user interface is very simple. After power-on, the type/model number of the
controller appears on the front panel of the device (displays “
C14”
), followed by a 3 second delay after which
the actual temperature will be displayed. Pressing the programming (
P
) button allows for viewing of the
temperature set point, displayed as ‘Set’, followed by the set point temperature. The menu automatically
returns to the main display (actual temperature) after 5 seconds. Access to the controller parameter list is
achieved by pressing and holding the “P” button for 3 seconds (after which “P10” appears on the display).
Pressing and holding button “P” for an additional 3 seconds provides display “P” of “dC” for degrees
Centigrade or “dF” for degrees Fahrenheit.
ELTC-14 Display / User Interface
LED (1) ON
Heater Relay ON
LED Blinking
Function Delayed
LED (4) ON
Alarm Relay Activated
LED blinking
Function Delayed
To Next Page
Loading...
Need help?
General
