11
Your Embertec Emberstrip™ AV
+
is equipped with a number of settings to
suit your lifestyle. You can set your timer to either 1 or 2 hours, depending
on usage habits. This means the SmartSensor will flash after the set period,
warning of imminent power down. In every case you can continue using
your equipment by pressing the volume button on any remote control.
The default setting is 1 hour, which is aimed to maximise your energy savings.
Follow these instructions to change Active Powerdown™ to 2 hours, (this
may be preferred for longer movies or programs where remote control
activity is less frequent).
Music Mode
(8 hours)
Once (one second)
then release
1 hour
(default setting)
1 time
Please make sure the sensor has flashed back 1, 2 or 3 times
To set the Active
Powerdown™
timer to:
Press the button
on the
SmartSensor:
To confirm the setting,
the LED light on the
SmartSensor will flash:
1. Ensure your Audio Visual (AV) equipment is switched on.
Twice (one second
each) then release
2 hours 2 times
Three Times
(one second each)
then release
3 times
Changing settings for Active
Powerdown™ using the SmartSensor
To Next Page
Loading...