4
Turning ON your AV Equipment
• To operate your Audio Visual (AV) components, press the volume button
on any existing remote control(s), or press the button on the SmartSensor.
This will apply power to all components and place them in standby mode,
ready for use. You can continue using your existing remote(s) to operate
your television or other Audio Visual (AV) components in the normal way.
NOTE: To reactivate your TV components, you may be required to press
the power button again on the relevant remote control after power has
been restored.
Turning OFF your AV Equipment
• Simply turn your equipment off in the normal way. Once the Audio
Visual (AV) components have been switched off, the Embertec Emberstrip™
AV
+
will remove power from the Power Saver sockets after a delay of
approximately 1 minute.
NOTE: The LED light on the SmartSensor will flash for about 60 seconds
to warn you that power is about to be removed from the AV 'Power
Saver' sockets.
SmartSensor
The SmartSensor receives signals from any of your remote controls
and recognises when you are interacting with your Audio Visual (AV)
components. The SmartSensor is also used to get the time period for
the Active Powerdown™ feature. SmartSensor default setting for Active
Powerdown™ is 60 minutes.
Quick Operation Guide
To Next Page
Loading...