39
Install - Step 7 continued
Power up and cable optional DAEs
Use 1-meter cables to connect contiguous enclosures. Use longer cables to skip over enclosures
or to connect DAEs between cabinets.
3. Repeat steps 1 and 2 for the LCC B (left) side of bus 0.
4. Apply cable label bands (provided with your system) to identify the bus number
for each back-end cable.
The configuration example below shows a CX4-120 with eight DAE disk-array
enclosures.
Each device in the example connects to the Primary disk enclosure connectors of
the device above it, and subsequent enclosures connect in an expansion-to-
primary chain. Note also that each device supports two completely independent
and redundant loops, A and B.
CL4157
To Next Page
Loading...
