51
Install the VNX5300 SPS
Assistance is required when moving or installing the VNX5300.
1. Slide the standby power supply (SPS) enclosure into the bottom slot of the ganged rails.
2. When the SPS is securely in place, insert one screw on each side and hand-tighten them to
hold it in place in the cabinet.
Standby power supply enclosure
Front
SPS 1 unit bracket
The indentation
toward the inside of
the rack.
Maximum
rail extension
The SPS is heavy and should be installed into a rack by two people. To avoid personal injury
and/or damage to the equipment, do not attempt to lift and install the enclosure into a rack
without a mechanical lift or help from another person.
CAUTION
To Next Page
Loading...
