Emec LOTUS MAXI - Page 46

8.
LOTUS Terminal board
6(35PRGXOHIRUSUR[LPLW\
VZLWFK
6ORW
0'6(35

To set the proximity switch enter into configuration menu and select
Probe Flow Alarm
Flow contact can be enabled to stop a dosing procedure using a N.O.
contact mode (normally open) or N.C. contact mode (normally clo-
sed) when status on blocks changes. Rotate wheel to choose
between: “DISABLE”, “REVERSE” (N.O. contact) or “DIRECT”
(N.C. contact). Furthermore “Flow contact” can starts after a speci-
fied time when contact status changes. To set it move wheel on
“Time:00 min”, click it and rotate to choose time (from 0 to 99 mi-
nutes). Confirm selection by clicking wheel
.
This function is available only with Cl module installed.
0'0$PRGXOH
P$ZDWHUPHWHU
LQSXW6ORW


0'0$

&RQWDFW%ODFN
QD
9'&%URZQ
*1'%OXH
&855(172873879(56,21P$PDLQERDUGEORFNV
&DSDFLW\
5HDGLQJ