Emerson 500 Series - Model Number Configuration; Series and Voltage Codes; Protection Modes and Enclosure Types; Connection Types and Monitoring Options

Installation, Operation and Maintenance Manual IO-70100 Rev 3 7-15

Warning: Indicate[s] a
hazardous situation which, if not avoided,
could result in death or serious injury.
WARNING [signs] should not be used for
property damage hazards unless personal
injury risk appropriate to this level is also
involved.
Avertissement: Indique une situation
dangereuse qui, si elle n'est pas évitée,
pourrait entraîner la mort ou des blessures
graves. Les signes AVERTISSEMENT ne
doivent pas être utilisés pour les risques de
dommages à la propriété, sauf si le risque
de blessures appropriées à ce niveau est
également impliqué.
Caution: Indicate[s] a
hazardous situation which, if not avoided,
could result in minor or moderate injury.
CAUTION [signs] without a safety alert
symbol may be used to alert against
unsafe practices that can result in property
damage only.
Attention: Indique une situation
dangereuse qui, si elle n'est pas évitée,
pourrait entraîner des blessures mineures
ou modérées. Les signes ATTENTION sans
symbole d'alerte de sécurité peuvent être
utilisés pour mettre en garde contre des
pratiques dangereuses qui peuvent
entraîner des dommages matériels
seulement.
Units that include the ACTIVE SURGE MONITOR option
3
1 2 3 4 5 6 7 8 9 10 11 12 13
MODEL NUMBER CONFIGURATION
Model #: _ _ _ _ _ _ _ _ _ _ _ _ _
(
11
)
Enclosure
N = Caseless (open style)
G = Type 4 (metal)
H = Type 4X (Stainless Steel)
J = Type 4X (Plastic)
F = Type 12 Flushmount (metal)
(12) UL 1449 Type
0 = No UL
1 = Type 1
2 = Type 2
3 = Type 3
4 = Type 4
(13) Accessories
S = Standard
X = SPD with additional
Options/Accessories
(
8
)
Modes of Protection
A = All Modes of Protection
B = L-N & N-G
E = L-L
F = L-N
G = L-G
(9) Connection Type
N = Wiring terminals/Lugs
R = Disconnect
B = Bus Connected
C = Circuit Breaker
T = Internal Disconnect
(10) Monitoring Options
R = LED/Relay
A = LED/Alarm/Relay
C = LED/Alarm/Counter/Relay
D = LED/Alarm/DualCounter/Relay
T = Active Surge Monitor
See
“
Q
S
-70109” or “IO-70109”
(
1-3
)
Series
560 = Modular MOV
570 = Modular SAD/MOV Hybrid
(4-5) Configuration & Voltage
See Chart Below
(6-7) Surge Rating Per Mode
08 = 80kA
12 = 125kA
16 = 160kA
20 = 200kA
25 = 250kA
30 = 300kA
37 = 375kA
50 = 500kA
Active Surge Monitor
Refer to quick start guide
QS-70109 or manual IO-70109
for additional installation and
o
p
eration instructions. 
Courtesy of NationalSwitchgear.com