Emerson AMS 2140 - Verify AMS Machinery Manager Version; Check AMS Machinery Manager Compatibility

7 Verify the AMS Machinery Manager version
The AMS 2140 Laser Align Application is compatible with AMS Machinery
Manager v5.61 or later.
AMS Machinery Manager 5.61 may require a patch to enable full
functionality. If you are using AMS Machinery Manager v5.61, perform the
following steps to verify that the patch is installed on your PC.
Procedure
1.
From AMS Machinery Manager, click Help > About AMS Suite: Machinery Health
Manager and verify the version you are using is v5.61.
2. Select the Tools tab.
3. From the Filters pane, select Document/Reporting.
4. Double-click Alignment Jobs to launch the UltraAlg application.
5. From the UltraAlg application, click Help > About.
Verify the release date of the UltraAlg application. It should be June 30,
2015 or later.
About AMS Machinery ManagerFigure 7-1:
Quick Start Guide December 2018
38 AMS 2140 Advanced Laser Alignment Application