Junction box wiring notesFigure 4-2:
A. Maintain cable pair twists as close to the terminal block as possible.
B. Do not allow shield drain wires or foil from individual cables to short. Use heat shrink and dress
wire ends as necessary.
C. Strip the insulation and shield as close to the terminal block as possible.
D. Connect multiple-pair shield drain wire individually. Do not allow shield drain wires or foil from
individual cables to short. Use heat shrink and dress wire ends as necessary.
Enclosure mounting
MHM-97125-PBF-EN, R0 17
To Next Page
Loading...
