Configuration
[51]
CAUTION!
Figure 8-11: Button Reset to factory default
This command requires an online connection to the converter.
The preset configuration on the converter including the calibration data will be deleted and
replaced by the default configuration.
Compare
Click Compare to show differences between the configuration on the converter and in the
memory of the used Laptop or PC.
Figure 8-12: Button Compare
Report
Click Report to open the report viewer. This report shows all configured parameters and
some additional information, such as serial number and user information. This report can
be exported to different formats, such as PDF, XPS, and Microsoft Excel, or it can be
printed.
Figure 8-13: Button Report
Where required, change the logos in the header of the report:
1. Close the configuration editor. The configuration is automatically saved as a draft
configuration.
2. Click File and then Settings.
To Next Page
Loading...