Configuration
[53]
Figure 8-16: History
The right part of
Figure 8-16
shows the configuration history. The individual files are
marked with date, time, and type:
• Draft Config
A saved preliminary configuration file which has not yet been sent to the converter.
•
Running Config
This configuration file is running on the connected converter.
• Running Config (historic)
An old configuration file which was running in the past.
The editor area is grayed out. You can see the parameters of the historic files, but you can
not change them. Parameters can only be changed in the editor. To copy a historic
configuration to the editor:
1. Select a draft or historic file from the list.
The parameters of the selected file are displayed in the grayed out editor area.
2. Click Revert. The selected file is copied to the editor, and the history window is
closed. Click Show History/Drafts again, if you want to leave the history without any file
copying.
Figure 8-17: Button Revert
Close configuration
Click Close configuration to leave the editor. Changes are automatically saved as a draft
configuration. Use the history view to open saved draft configurations.
To Next Page
Loading...