Emerson AMS Trex - Send a Configuration to a Connected HART Device; Save a Configuration from a HART Device; Offline HART Configurations

3.14.8 Send a configuration to a connected HART device
Prerequisites
You must have at least one configuration saved in the Trex unit for the connected device
type.
Procedure
1. Connect to the HART device.
2. Tap the Menu tab in the application bar.
3. Tap Send Config.
4. Select a saved configuration, and tap OK.
5. Review the parameters, and tap Send.
3.14.9 Save a configuration from a HART device
You can save a copy of the configuration from the connected device. The configuration has
only non-dynamic parameters.
Procedure
1. Connect to the HART device.
2. Tap the Menu tab.
3. Tap Save Config.
4. Enter a filename for the configuration, and tap OK.
The configuration is saved in the Trex unit.
3.15 Offline HART configurations
The Trex unit lets you work with HART configurations. You can create, edit, copy, delete,
and rename configurations.
If you are not connected to a HART device, an Offline Config button displays on the main
Field Communicator menu. You can edit and store a configuration on the Trex unit.
If you are connected to a HART device, you can either Save Config to the Trex unit, or Send
Config to the connected device.
You can also back up the configurations to a PC by using the Configuration Management
application. For more information, see the Help included with the Configuration
Management application.
Note
Do not edit a configuration on the Trex unit while you are connected to the Configuration
Management PC application.
Field Communicator application
User Guide 89