Emerson AMS - 4.5 Close the AMS Asset Monitor; 4.6 Recommended sequence for installing the AMS Asset Monitor

4.5 Close the AMS Asset Monitor
Prerequisites
• A PZ 3 cross-tip screwdriver for the door screws.
Procedure
1. If the door has been removed completely, hang the door on its hinges.
2. Secure the lower hinge with the circlip.
Figure 4-9: Reattach the door
A. Mounting direction
B. Screws for securing the door
C. Circlip
3. Close the door and secure it by fastening the screws.
Tighten the screws until the door touches the base, and is squeezed to ensure a
proper seal.
4.6 Recommended sequence for installing the AMS
Asset Monitor
The described installation sequence is a recommendation and can be changed to the
needs of your project.
Procedure
1. Remove the door of the AMS Asset Monitor.
2. Mount the AMS Asset Monitor.
Installing AMS Asset Monitor hardware Installation Guide
March 2024 MHM-97923-PBF
30 MHM-97923-PBF, Rev. 2.10