3. Mount cable glands or sealing blind plugs.
4. Install the +24 V DC Power Module.
5. Install the desired CHARMs with terminal blocks.
6. Install the address block.
7. Connect the field wiring.
8. Connect the Ethernet network.
If more than one AMS Asset Monitors are installed, Emerson recommends to daisy
chain them.
9. Connect the power supply and the grounding.
10. Check the installation by checking all cable connections, the power supply voltage,
the LEDs on the devices, and testing the field wiring.
11. Reattach the door.
4.7 Mount the AMS Asset Monitor
Prerequisites
You need two people to lift the AMS Asset Monitor and fix it on the mounting place.
Procedure
1. Remove the door of the AMS Asset Monitor. See Open the AMS Asset Monitor.
2. Prepare the mounting place. Check if available holes fit to the hole pattern of the
AMS Asset Monitor. If not, drill suitable holes according to the hole pattern. See
Position of the mounting holes.
The required diameter and depth of the holes depend on the selected fixing
method.
3. Lift the AMS Asset Monitor on the mounting place.
Ensure that the cable entries point downwards.
4. Fix the AMS Asset Monitor with screws.
The tightening torque depends on the selected screws.
5. Reattach the door. See Close the AMS Asset Monitor.
4.8 Mount the AMS Asset Monitor by using the
universal mounting bracket
Use the universal mounting bracket SE8701UMB if the AMS Asset Monitor must be
mounted at a post. The bracket is compatible with square profile posts or round profile
posts with the following dimensions:
• Round profile: outside diameter from 50 mm (2.0 in) to 88 mm (3.5 in).
• Square profile: maximum side length 88 mm (3.5 in). Reverse the clamping jaws.
• When installing a new post, Emerson recommends a post with a wall thickness of 3.2
mm (1/8 in).
Installation Guide Installing AMS Asset Monitor hardware
MHM-97923-PBF March 2024
MHM-97923-PBF, Rev. 2.10 31
To Next Page
Loading...
