5.8.1 Connect the sensor wiring
Figure 5-17: Sensor connection
A. RTD CHARM
B. CHARM Baseplate
C. CHARM Terminal Block
D. 4-wire RTD
E. Cable shield connection
F. 3-wire RTD
G. 2-wire RTD
Prerequisites
• Wire cutter
• Tool for removing the cable sheath
• Wire stripper
• Suitable screw driver for the CHARM Terminal Block screws
• Observe the hints in Wiring guidelines.
Installation Guide Installing CHARMs hardware
MHM-97923-PBF March 2024
MHM-97923-PBF, Rev. 2.10 63
To Next Page
Loading...
