Emerson Bettis SCE300 - Open Limit Configuration; Close Limit Configuration by Torque; Open Limit Configuration by Torque

34
February 2020
Installation and Maintenance Instructions
MAN-02-04-99-0712-EN Rev. 1
Actuator Configuration
Section 6: Actuator Configuration
6.2.5 Open Limit Conguration
• Move switch SW 3 to position ON
• Drive the actuator to open position using the handwheel.
• Move switch SW 4 to position 1
• Move switch SW 6 to position 0
• Conrm by pushing ENTER pushbutton SW5
• When pushing SW5, the red LED switches ON for conrmation
• Exit setup conguration by moving switch SW3 to position 1 or proceed with the
next parameter
6.2.6 Close Limit Conguration by Torque
• Move switch SW4 to position 2
• Move switch SW6 to position 0
• Move switch SW3 to position ON
• Conrm by pushing ENTER pushbutton SW5 (red LED switch on)
• Operate the actuator to closing direction by local/remote control and wait until it
stops by torque
• When the setting is complete, the red LED switches off
• Exit setup conguration by moving switch SW3 to position 1 or proceed with the
next parameter
6.2.7 Open Limit Conguration by Torque
• Move switch SW4 to position 3
• Move switch SW6 to position 0
• Move switch SW3 to position ON
• Conrm by pushing ENTER pushbutton SW5 (red LED switch on)
• Operate the actuator to opening direction by local/remote control and wait until it
stops by torque
• When the setting is complete, the red LED switches off
• Exit setup conguration by moving switch SW3 to position 1 or proceed with the
next parameter