Emerson Bettis SCE300 - Section 8: Decommissioning; Disposal and Recycling

46
February 2020
Installation and Maintenance Instructions
MAN-02-04-99-0712-EN Rev. 1
Decommissioning
Section 8: Decommissioning
Section 8: Decommissioning
8.1 Disposal and Recycling
Once the SCE300 actuator reaches the end of its service life, the device must be
disassembled. Do not dispose of non-biodegradable products, lubricants, and non-ferrous
materials (e.g. rubber, PVC, resins) by simply dumping them into the environment; rather,
dispose of such materials as indicated by the following table:
Table 8.
Subject Hazardous Recyclable Disposal
Electrical and
electronic equipment
Yes Yes Use specialist recyclers
Glass No Yes Use specialist recyclers
Metals No Yes Use licensed recyclers
Plastics No Yes Use specialist recyclers
Rubber
(seals and O-rings)
Yes No
Will require special treatment before
disposal; use specialist waste
disposal companies
Oil and grease Yes Yes
Will require special treatment before
disposal; use specialist recyclers or waste
disposal companies
Batteries Yes Yes
Will require special treatment before
disposal; use specialist recyclers or waste
disposal companies
NOTICE
Do not re-use parts or components that have been declared unsuitable for use by
qualied personnel.
NOTE
Check with local regulatory authorities before disposing of any components.