Emerson Copeland EazyCool ZX Series - Table 11: Defrost Parameters

14 C6.1.6/0613-0915/E
Parameter
Description
Factory settings /
Range
Recommended setting / Comments
G23**
Defrost interval
mode
0 = Not used = NU
0 = NU = Not used; 1 = IN = Interval;
2 = rtC = Real time clock
G24***
Display during
defrost
DEFROST "dEF"
0 = DEF = Defrost; 1 = Set = Case temp.
setpoint; 2 = it = Case temp. value;
3 = rt = Standard operation
G25
Maximum display
delay after
defrost
0 minute
0 – 255 minutes
G26
Drip time
1 minute
0 – 120 minutes
G27
Defrost at power-
on
0 = NO
Avoids defrost after initial power up. If
"YES", the controller will decide on defrost
related parameters if a defrost sequence is
required after initial start-up
G28
Workday defrost
start 1
00:00
00:00 – 23:50 or NU = Not used
G29
Workday defrost
start 2
04:00
00:00 – 23:50 or NU = Not used
G30
Workday defrost
start 3
08:00
00:00 – 23:50 or NU = Not used
G31
Workday defrost
start 4
12:00
00:00 – 23:50 or NU = Not used
G32
Workday defrost
start 5
16:00
00:00 – 23:50 or NU = Not used
G33
Workday defrost
start 6
20:00
00:00 – 23:50 or NU = Not used
G34
Holiday defrost
start 1
00:00
00:00 – 23:50 or NU = Not used
G35
Holiday defrost
start 2
04:00
00:00 – 23:50 or NU = Not used
G36
Holiday defrost
start 3
08:00
00:00 – 23:50 or NU = Not used
G37
Holiday defrost
start 4
12:00
00:00 – 23:50 or NU = Not used
G38
Holiday defrost
start 5
16:00
00:00 – 23:50 or NU = Not used
G39
Holiday defrost
start 6
20:00
00:00 – 23:50 or NU = Not used
G40
First weekly
holiday
SUN = Sunday
0 = SUN; 1 = MON; 2 = TUE; 3 = WED;
4 = THU; 5 = FRI; 6 = SAT;
7 = NU = Not used
G41
Second weekly
holiday
SUN = Sunday
0 = SUN; 1 = MON; 2 = TUE; 3 = WED;
4 = THU; 5 = FRI; 6 = SAT;
7 = NU = Not used
G42****
Fan operating
mode
0 = cn = Stopped
during defrost
0 = cn; 1 = on; 2 = cy; 3 = oy
G43
Fan stop
Temperature
0°C
-40°C – 110°C
G55
Fan delay after
defrost / drip time
1 minute
0 – 255 minutes
S05
Relay output 2
configuration
0 = Not Used = NU
6 = Defrost = DEF
Table 11: Defrost parameters