Quick Installation Guide Damcos KC Actuators: Adjustment of the DPI
QIG 8000-81-003 Ed 01 February 2020
20
7. Remove the screw (a) and
loosen the locking set
screw (b).
8. Unscrew the DPI until
there is a gap of
3-4 mm between the con-
trol block and the DPI
flange.
9. Check the ‘Closed’ signal.
There should be no sound
(or Ω display should show
more than 300/1500).
10. Now use the fork wrench
to slowly tighten the DPI
socket until the multime-
ter makes a sound signal
(or Ω display shows 300/
1500).
11. After ‘Closed’ sound sig-
nal (or Ω display 300/
1500), tight
en the DPI
socket another 45-90
degrees.
To Next Page
Loading...
