Emerson daniel 1500 series - Page 68

Display, actions and settings (continued)Table 6-1:
Parameter Display Action/Setting
Display 2 dSP 2 Output display 2 value
Output 2 Out 2 Output 2 value
Save SAVE? Save entered analog parameters
Disable dSAbL Turn off the analog output
Gate GATE Enter Gate menu
Low gate LO Set Low gate
High gate HI Set High gate
Filter FILTER Enter Filter menu
High speed filter HI Set high speed filter
Medium speed filter mEd Set medium speed filter
Low speed filter LO Set low speed filter
Low-flow cutoff CUTOFF Enter Low-Low cutoff menu
Scale & calibrate SCALCAL Enter the Scale & Calibrate menu to pro-
gram without using a K-Factor
Scale SCALE Enter the Scale menu
Calibrate CAL Enter the Calibrate menu
Undo K-Factor Undo? KFACTOR Undo the K-Factor input programming
Undo scaling & cali-
bration
Undo? SCALCAL Undo the scaling and calibration input pro-
gramming
No no? Do not undo other programming
Yes YES? Undo other programming
Number of points noPtS Enter the number of scaling or calibration
points
Input 1 InP 1 Calibrate or scale input 1 value
Display 1 dSP 1 Program display 1 value
Input 2 InP 2 Calibrate or scale input 2 value
Display 2 dSp 2 Program display 2 value
Save SAVE? Save entered calibration or scale parame-
ters
Total reset T RESET Enter the Total Reset menu
Total reset t rSt Select the Total Reset method
Manual mAn Manual total reset
Enable EnAbl Enable manual reset
Disable dSAbL Disable manual reset
Automatic Auto Automatic total reset
Time delay T DELAy Automatic reset time delay
Grand total reset GtrSt Select the Grand Total Reset method
Product advanced features
56 LTM Internal Display