Emerson daniel 1500 series - Page 70

Display, actions and settings (continued)Table 6-1:
Parameter Display Action/Setting
Log view LOGVIEW View data log
All log view ALL LOGVIEW View all data log points
Log number LOG NUM Go to specific log number
All erase ALL ERASE Erase all logs
Erase? ErASE? Confirm to erase all logs
Backlight BAKLITE Enable or disable backlight
Disable dSAbL Disable backlight
Enable EnAbl Enable backlight
Analog output cali-
bration
AO CAL Enter Analog Output Calibration menu
Backup BACKUP Enter Backup menu
Save? SAVE? Save current parameters to backup restore
Load? LOAd? Load parameters from backup restore
Default dEFLt Restore factory default parameter settings
Reset defaults rESEt DFALTS? Confirm factory reset
Battery symbol BAt SyM Enter Battery Symbol menu
Disable dSAbL Disable battery backup symbol
Enable EnAbL Enable battery backup symbol
Info INFO Enter Info menu
Software SOFt Display software ID number
Version VEr Display software version number
Model modL Display model number
Communications COMM Enter Communications menu
Modbus mbuS Enter Modbus communications menu
Slave ID SLU Id Set Modbus slave ID
Baud rate bAUd Set baud rate
Transmit delay tdELY Set transmit delay time
Parity PArtY Set parity and stop bits
Standby STANDBy Enter standby mode (battery powered on-
ly)
Yes? YES? Confirm standby mode
Product advanced features
58 LTM Internal Display