Emerson daniel 1500 series - Startup Procedure; Operation and Startup Basics

7 Startup procedure
Topics covered in this chapter:
•
Operation and startup procedure
•
Button tips
•
Grand total reading (Gr TOTAL)
•
Max/Min readings (MAXIMUM, MINIMUM)
•
Reset the total (rESEt TOTAL?)
•
Reset the grand total (rESEt Gr TOT?)
•
Reset Max/Min readings (RESET MAXIMUM, MINIMUM)
•
Reset meter to factory defaults
•
Factory defaults and user settings
7.1 Operation and startup procedure
Through-glass button operation
To actuate a button, press and move one finger to the glass directly over the marked
button area. Reposition finger to at least 4 inches away from the glass in between button
activations. Through-glass and manual buttons may be held to cycle through menus or
digits instead of repeatedly pushing a button.
Important
Through-glass buttons will not work if two or more buttons are pressed simultaneously. Avoid
triggering multiple buttons by reaching across one button location to press another button.
Front panel button operationTable 7-1:
Symbol Description
1.
Hold the Menu button when in power save mode (display will show ) to
awaken through-glass buttons.
2. Press the Menu button to enter Programming Mode.
3. Press the Menu button during Programming Mode to return to the previous
menu selections.
4. Hold the Menu button for 1.5 seconds at any time to exit Programming
Mode and return to Run mode.
5. Press and hold the Menu button for 3 seconds to access the Advanced fea-
tures of the meter.
6. Press and hold the Menu button for 3 seconds to access the Advanced fea-
tures of the meter.
Startup procedure
User manual 87