Emerson Daniel 3414 - Replace the CPU Module or Optional I;O Module

The Daniel 3410 Series Gas Ultrasonic Flow Meter Base Enclosure consists of the following:
• Acquisition Module (P/N 1-360-03-008)
• Acquisition Cable (P/N 360-01-595)
Should the Daniel 3410 Series Ultrasonic Gas Flow Meter require disassembly in the field
(i.e., check boards, change switch settings, or replace boards), to prevent electrostatic
damage to the electronic boards, always use a ground strap while handling the circuit
boards. If one is not available, make sure you are electrically discharged before touching
the boards by first touching a metal surface such as a ground lug on the meter or a table.
3410 Series electronicsFigure 3-16:
A. Terminal end of Transmitter Electronics Enclosure
B. Backplane board location
C. End cap security latch
D. Base enclosure with Acquisition Module
3.6.1
Replace the CPU Module or Optional I/O Module
1. Remove power to the meter.
Meter repairs
Maintenance and Troubleshooting manual 69