Figure 3-13: Setting of T-200 transducer capsule assembly
A. Tab
B. Position 1
Figure 3-14: T-200 transducer stalk assembly configuration
A. Stalk assembly configuration
B. Transducer stalk
C. Stalk assembly serial number
3. Ensure that the setting of the transducer capsule assembly matches the stalk
assembly configuration (see Table 3-3). The setting of a transducer capsule
assembly is indicated by the number next to the slot where the tap is located (see
Figure 3-13), i.e. 1, 2, ... 8. The stalk assembly configuration is labeled on the
Meter repairs Maintenance and Troubleshooting manual
July 2020 3-9000-769
68 Gas Ultrasonic Flow Meters
To Next Page
Loading...
