Emerson Daniel Danalyzer 1000 - Page 134

SEP 2005 MODEL 1000
INSTALLATION AND SETUP
3-80
Parallel I/O VCC Enable
The I/O connectors can provide +5 volts to an I/O rack or for miscellaneous purposes by jumpering
J2. When J2 is jumpered +5 volts are provided at pin 49 of both J4 and J7. It the user's responsibility
to limit current to a safe value (less than 1A) to avoid damaging the CPU Board. The jumper
definitions for J2 are shown here:
Figure 3-35. I/O VCC Enable