SEP 2005 MODEL 1000
2350 to 2350A CPU RETROFIT INSTRUCTIONS
F-18
(6) Locate the System Interface and Driver board. It is mounted to the top of the Card Cage
Assembly.
(a) Disconnect the Analog cable from J6 of the System Interface Board, then disconnect
all CPU cables from the System Interface Board.
(b) Remove the CPU assembly and install the Ethernet assembly with associated
hardware into J19 and J20 PC/104 Bus connector on the CPU assembly.
If an option board is already plugged into the PC/104 Bus on the CPU, install the Ethernet
assembly and mounting hardware into the PC/104 Bus connector on the option board.
c) Plug one end of the Ethernet extension cable (P/N 3-2350-088) into J5 of the
Ethernet assembly. The in-line jack on the remaining end of the Ethernet extension
cable attaches to the lower left inside wall of the card cage shield (after the CPU
assembly is reinstalled and all cables reconnected to the System Interface Board). No
software setup is required for this board.
d) If the 2350A BOS version is v1.84 or later, ensure that J6 Jumper on pins 13-14 of
J1 has been removed. See Figure F-8 and Figure F-9
Figure F-8. Ethernet Jumper Configuration BOS v1.82 and Earlier
To Next Page
Loading...
