MODEL 1000 SEP 2005
INSTALLATION AND SETUP
3-15
3.2.3 Unpacking the Unit
1
Observe Precautions and Warnings
2
Plan Site Location
3
Obtain Supplies and Tools
»
4
Install Analyzer Wiring
Observe the following checklist for unpacking the unit and inspecting for damage:
(1) Unpack the equipment:
(a) Model 1000 series Analyzer
(b) GC Controller
(2) Ensure that all documentation and software are included:
(a) This manual, the Model 1000 Gas Chromatograph Hardware Reference Manual,
P/N 3-9000-541.
(b) The software manual, MON2000 Software for Gas Chromatographs User Manual,
P/N 3-9000-522.
(c) CD(s) with the MON2000 software program and GC Applications.
Installation and startup of the GC System should proceed only if all required materials are on hand
and free from obvious defects. If any parts or assemblies appear to have been damaged in shipment,
first file a claim with the carrier. Next, complete a full report of the nature and extent of the damage
and forward the report immediately to Daniel Measurement Services (DMS), a division of Emerson
Process Management for further instructions. Include complete model number information.
Disposition instructions will be returned immediately by Daniel Measurement Services. Refer to the
Customer Repair Report in the back of this manual.
To Next Page
Loading...
