Emerson DL8000 - Page 147

DL8000 Preset Instruction Manual
Revised February-2016 Communications Protocols D-19
Authorize Transaction
[0x06]
Exceptions
 Passcode Entry in Progress
 Primary Alarm active
 Transaction Authorized
 Operating Mode is Manual
 K&D Locked Out
 Invalid recipe number (Recipe selected
[63,0,10] is more than number of recipes
[63,0,26])
 No recipe selected (recipe selected [63,0,1] is
0)
 Invalid additive selection method [63,0,102]
 Invalid additive selection
 Invalid swing arm side (applicable only for
Version 2.0 and later)
 Recipe verification fail (error code [63,0,95] is
set)
 Additive user program is not running in
DL8000
 Additives module is running in DL8000 and
suggested additive method [63,0,170] is not
either 0 or 1. Returns Invalid additive selection
method exception.
 Suggested additive method [63,0,170] is 0 and
additive bitmap [63,0,112] is set to more than
configured number of additives [63,0,100].
 Suggested additive method [63,0,170] is 1 and
additive bitmap picked up (as per the additive
selection method) has additive bits set more
than configured number of additives
[63,0,100].
Supporting
Parameters
 Additive selection method [63,0,102]
 New recipe selection [63,0,10]  [63,0,118]
 Suggested additive method [63,0,170]
 Forced additive selection bitmap [63,0,60] 
[63,0,112]
 No. of additives [63,0,100]
 Number of data items [63,0,186]
 Data items [63,0,188;190;192;194;196]
Results
When transaction gets authorized, the system
assigns it a transaction sequence number
[63,0,124]. In auto operating mode, the
configuration parameters are locked when
transaction is authorized.