Emerson DL8000 - Page 173

DL8000 Preset Instruction Manual
Revised February-2016 Communications Protocols D-45
Request Status
[0x12]
Results
The response frame includes the following
parameter values:
 Status flags [63,0,119]
 Current swing arm side [63,0,145] (only for
version 2.0 and later)
 Batch gross volume [63,0,135] or Composite
Batch gross volume [63,0,2] based on Preset
Additive Option [64,0,26] is set as “Exclusive”
or “Inclusive” respectively.
Note: Composite Gross available only for
version 2.0 and later.
 Batch Net Standard [63,0,137] or Batch Mass
[63,0,138] based on delivery type.
 Status of safety circuit inputs [63,0,98]
Note: If you do not configure a safety circuit,
the status of that circuit becomes 0.
 Alarm ID of oldest highest priority active alarm
[63,0,111] – returned alarm code is in terms of
DanLoad 6000. Value stored at this parameter
is alarm code used by DL8000 which may not
match with alarm code of DanLoad 6000.
 Alarm bitmaps of ten bytes (returned in terms
of DanLoad 6000 alarm bytes)
Deviations
 For the DanLoad 6000 protocol, alarm bitmaps
of ten bytes returned contain only the status of
primary alarms. However, the DL8000 returns
the status of active alarms regardless of alarm
severity.
 The DanLoad 6000 protocol can be used only
on a single port and only on Comm A.
 Swing arm side is not supported in DL8000, so
it always returns a value of 1 in the command
response frame (valid only for version 1.0).
 Preset Additive Option [64,0,26] is an
additional feature not available in the DanLoad
6000 protocol. (Valid only for Version 2.0 and
later)