DL8000 Preset Instruction Manual
Revised February-2016 Communications Protocols D-63
Change
Operating Mode
Results
The DL8000 changes the operating mode as
requested and displays a new screen based on
the new mode.
No batch stopped
Clear Display
[0x38]
Clears the DL8000’s multi line display.
Use this command to erase recipe menu content after a prompt recipe
command, additive menu content after a prompt additive command, loading
screen content after an authorized transaction command, a prompt preset
volume command or an authorize batch command.
Flags Immediately Set
None
Flags Immediately
None
Exceptions
Passcode Entry in Progress
Operating Mode is Manual
K&D Locked Out
Supporting
Parameters
None
Results
Clears existing screen and displays a “Please
wait” message until the next TAS command. The
alarm and date-time continue to display.
Deviations
None
Request Stored
Transaction
[0x39]
Use this command to request the transaction record from the (transaction
storage) transaction file. You can configure the format of the transaction
record and the DL8000 only archives the configured parameters. Valid
transaction sequence numbers are 0 through 9999.
Flags Immediately
None
Exceptions
1Dh Transaction not on file
03h Response Data Field Too Long (currently
not generated)
Supporting
None
Results
The DL8000 customizes the response frame when
returning the transaction record, as described in
the Deviations section.
Currently, the DL8000 does not raise the
exception Response Data Field Too Long in this
command. The maximum data length (when all
transaction data is configured to be archived) is
less than maximum data that can be sent through
the response frame.
Deviations
The command query frame has the following
format:
struct Tasq
{
Unsigned char dfl; // datafield length
To Next Page
Loading...
