Emerson DL8000 - Page 197

DL8000 Preset Instruction Manual
Revised February-2016 Communications Protocols D-69
Enhanced
Start Communications
[0x3B]
Results
The command response frame consists of the
following parameters:
 Number of meters [63,0,20]
 Number of components [63,0,21]
 Number of valves [63,0,19]
 Number of factors or flow rate [63,0,109]
 Number of recipes [63,0,26]
 Number of additives [63,0,100]
 Temperature Units Option [70,0,2]
 Temperature correction option [71,x,28]
 Pressure correction option [71,x,29]
 Number of data items [63,0,186]
 Language used [63,0,14]
Deviations
 The Temperature correction option [71,x,28]
values the DL8000 returns do not directly map
to the DanLoad 6000 program codes 432,
435, etc. for all values.
 The Pressure correction option [71,x,29]
values the DL8000 returns do not directly map
to the DanLoad 6000 program codes 444,
447, etc. for all values.
 Swing arm side is not supported on DL8000,
so its value returned in the command
response frame is always 1 (applicable only
for Version 1.0).