Emerson DL8000 - Page 295

DL8000 Preset Instruction Manual
Revised February-2016 DL8000 Keypad Display E-77
Press SELECT to specify a DO channel number for testing:
 14/03/12 12:26:02
Test DO Ch
Use DI Ch
(SELECT)
DO ch 1
Press SELECT to specify a DI channel number which is connected to
the test DO:
 14/03/12 12:26:02
Test DO Ch
Use DI Ch
(SELECT)
DO ch 1
DI ch 1
Note: For an external source (relay, sol, etc.), select NONE.
 14/03/12 12:26:02
Test DO Ch
Use DI Ch
(SELECT)
DO ch 1
NONE
When you select the DI channel option, the program displays the current
status of the DO and DI.
 14/03/12 12:26:02
Test DO Ch
Use DI Ch
DO Current Status
DI Current Status
(SEL to toggle Sts )
DO ch 1
DI ch 1
OFF
OFF
(STOP to End )
The current status of the DI should match the status of the connected
DO channel (if you defined that). If you are using an external device,
the system replaces the DI Current Status line with the message Check
Ext. Contact: